![]() The only way to remove that tint and adhesive is by removing your door panel, the entire door card, and everything else covering up the glass. If the film is cold, the film will tear, leaving tint and adhesive behind. Make sure the film is warm while you peel away the film but take caution you do not damage your door panel with too much heat. So, when you’re removing the film from the rollup windows, you need to be sure that you pull out that extra film tucked between the door frame and the glass. They will tuck a good quarter of an inch of the film down the edge of the door panel so you can roll your window up and down, and it’s not going to peel or wrinkle the lower edge of the film. Keep in mind that when you have had your windows professionally tinted, they will apply film to cover the entire glass. So only start the peeling motion when the film is warm. You want to encourage the film to come away from the glass. Make sure you are not tugging at the film. Once the film is warm, start pulling the film off the glass very slowly and gently. You can purchase protective gloves to protect your hands and be on the safe side. Take caution you do not burn yourself with the heat gun. When the film feels warm, and you can grasp an edge of the film with your thumb and forefinger, apply more heat and start pulling at the film. Then when you have found an edge, start picking at that edge of film until you have a starting point. Do the opposite if you wish if you are left-handed.Īpply heat to the film and glass in the lower left-hand or upper right corner. If you are right-handed, start removing your film from left to right. ![]() Hold it six inches from the window and apply heat to the glass. Turn on your heat gun and turn it to the highest setting. ![]() The critical part of removing window film is to apply heat onto the tint. Having the sun heat up the glass naturally helps soften the tint and makes it much easier to remove the film with the added use of the heat gun. We recommend you remove tint outside on a nice warm sunny day. ![]() You might even be able to rent one or borrow one from a friend who has a painting business. You can purchase a heat gun at any hardware store or online. But keep a new razor blade handy just in case some glue gets left behind on the glass. Hopefully, the heat gun will remove all traces of your film. You might have to remove that trim to access and remove the film trapped behind the frame and glass to perform a thorough job of removing all traces of window film. Keep that in mind.Ī professional window film installer will tuck the film behind the plastic trim. Your defroster will no longer work if you cut one of those lines. Making sure you don’t slice or break the filament. You have to painstakingly remove the adhesive from the glass and the defroster lines. If it doesn’t come off in one piece, removing the residue adhesive layer is a pain to remove. The adhesive layer should not separate from the film if you use the suggested method. If you do, it’s most likely going to cause the adhesive to remain on the glass when you peel off the layer of film. Make sure you don’t start picking and tugging at the film when the glass is cold.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |